Important: It is not allow changing ZTS-100 operation mode by change of power
source. It is need to follow the above steps to change ZTS-100 operation mode.
Add (Inclusion) ZTS-100 to Gateway / Controller Z-Wave network
Step
Procedure / Description
Gateway / Controller device should entry
the inclusion mode.
1
Press and hold "Home" key for 2 seconds
to entry the Add (Inclusion) / Delete
(Exclusion) Mode.
Press "Prog" key once, it will search the
2
network.
If the ZTS-100 is added into the network,
the signal of "done" will be shown.
3
Inclusion is completed.
Press "Home" key once to go back to the
4
home page.
LCD indication
MO
PROG ON
FAN AUTO
20
WAKE
AM
COOL