Physical Installation And Wiring - Remotec ZTS-100 User Manual

Inclusion
Controller
Scene
Association

Physical Installation and Wiring

CAUTION
- Read the enclosed instructions carefully before installing your new Z-
Thermostat. Pay close attention to all warnings and notes and carefully
follow the installation steps in the order they are presented to save time and
minimize the risk of damaging the thermostat or the system it controls.
- Turn off ZTS-100 and the electronic devices (e.g. heater, cooler) which will
be connected and the electric source before installation and maintenance. It
is highly recommended that the installation procedure is processed by
trained personnel.
Battery safety!
- Use new batteries of the recommended type and size only.
- Never mix used and new batteries together.
- To avoid chemical leaks, remove batteries from the ZTS-100 if you do not
intend to use the unit for an extended period of time.
- Dispose of used batteries properly; do not burn or bury them.
A controller containing network information about other
devices within the network and is used for controlling
devices. Inclusion controller is created from the Primary
Controller in a SIS enabled Z-Wave network. Inclusion
Controller has the ability to add and remove devices from
the network.
A collection of Z-Wave devices configured to turn to a
specific level, setting, mode, or perform an operation.
Scenes are usually activated by a controller, timed event, or
specific conditions.
Association is used to organize nodes in different groups
allowing the device to identify the nodes by a group
identifier. The groups can also be copied to other devices.
5