Install Liner Panels - Valor Legend G3.5 700IN Owner's Manual

Install Liner Panels

The following guidelines apply for all liner panels
(supplied separately).
1. Remove the rear log support (3 screws).
2. Remove the front brick support.
3. Inside the fi rebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
4. Place the rear panel against the back of the fi rebox,
on the ledge at bottom.
Installation
5. Rotate the anchor up and out of the way and slide
the left hand side panel against the fi rebox side.
Rotate the anchor back down to hold the panel.
6. Rotate the anchor up and out of the way and slide
the right hand side panel against the fi rebox side.
Rotate the anchor back down to hold the panel.
7. Tighten the side brick anchors on each side of the
fi rebox.
8. Install the top brick supporting it with the back and
side panels.
QUALIFIED
INSTALLER
27