Checking Pilot And Burner Flames - Valor Legend G3.5 700IN Owner's Manual

2. Place the window in its bottom railing and push its
top against the fi rebox.
3. While you hold it, unhook the side levers from the trim
supports and hook them into the window tabs.
4. Pull out the top of the window and release it to
ensure the springs return it.
IMPORTANT: To ensure a safe operation, ensure that
the levers are hooked properly to the window tabs.
5. Apply light hand pressure against the window frame
sides to bed-in the window seal.
6. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
7. Reinstall the access side doors to the fi replace.
8. Rehook the front trim fi tted with the barrier screen.
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front after
maintenance.
Owner's Information
Safety warning plate

Checking Pilot and Burner Flames

A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Correct Flame Picture
Pilot Flame can be
seen between logs
Logs
Correct Flame Picture
Pilot Flame can be
seen between twig
and rocks
Rocks
Thermocouple
Probe must be
in Flame
OWNER'S
INFORMATION
Pilot
Flame
7