Draytek Vigor2920 Series User Manual page 153

Available settings are explained as follows:
Item
Static IPv6 Address
configuration
Current IPv6 Address
Table
Static IPv6 Gateway
Configuration
After finishing all the settings here, please click OK to save the configuration.
D e t a i l s P a g e f o r I P
D e t a i l s P a g e f o r I P
This type allows you to setup 6in4 Static Tunnel for WAN interface.
Such mode allows the router to access IPv6 network through IPv4 network.
However, 6in4 offers a prefix outside of 2002::0/16. So, you can use a fixed endpoint rather
than any cast endpoint. The mode has more reliability.
Available settings are explained as follows:
Item
Remote Endpoint IPv4
Address
6in4 IPv6 Address
LAN Routed Prefix
Tunnel TTL
Description
IPv6 Address – Type the IPv6 Static IP Address.
Prefix Length – Type the fixed value for prefix length.
Add – Click it to add a new entry.
Delete – Click it to remove an existed entry.
Display current interface IPv6 address.
IPv6 Gateway Address - Type your IPv6 gateway address
here.
v 6 – 6 i n 4 S t a t i c T u
v 6 – 6 i n 4 S t a t i c T u
Description
Type the static IPv4 address for the remote server.
Type the static IPv6 address for IPv4 tunnel with the value
for prefix length.
Type the static IPv6 address for LAN routing with the value
for prefix length.
Type the number for the data lifetime in tunnel.
143
n n e l i n W A N 1 / W A
n n e l i n W A N 1 / W A
Vigor2920 Series User's Guide
N 2
N 2