Registering Bluetooth Unit - Kenwood DNX5360 Instruction Manual

Registering Bluetooth Unit

Registers the Bluetooth unit to be connected.
1 Display the Bluetooth Setup screen
>
Touch [ ] [ ]
(page 59)
2 Display the Connect Device List screen
3 Search for a Bluetooth unit
1 1 1
1 Displays the registered Bluetooth units.
The busy service becomes active. The available
service becomes inactive.
[ ] When appears, the text display is
scrolled by touching it.
[Search] Searches for a Bluetooth unit.
[SP DEV] Registers a Bluetooth unit that
cannot be registered by normal register
(pairing) operation.
⁄
• A new device cannot be registered if there are
already 5 Bluetooth units registered. Delete
unnecessary registration. See <Bluetooth Unit
Connection> (page 69).
>
[Bluetooth SETUP].
4 Select the Bluetooth unit to register
1 1 1
1 Displays the searched Bluetooth unit.
[Search] Searches for a Bluetooth unit.
[Cancel] Cancels searching of Bluetooth unit.
5 Enter PIN code
1 1 1
1 Enters a code number using the keypad.
[Enter] Confirms the entered PIN code. Enter
the PIN code specified for the Bluetooth unit
you are registering.
This button will not be active until at least four
PIN code digits have been entered.
[Cancel] Cancels registration of PIN code.
[Clear] Clears the code number.
⁄
• You can also register from the Bluetooth unit side. For
the PIN code necessary for registration, see <Registering
Bluetooth Unit PIN Code> (page 68).
• If the error message appears even though the PIN code is
correct, try <Registering Special Bluetooth Unit>.
Next page 3
English 67