Accessories ...1 DNX SERIES only ...1 * Accessory of DNX5360M. This accessory is used when connecting an external device to AV-IN jack on the front panel of this unit. For DNX SERIES only ...1 how to use this accessory, refer to the instruction manual of this unit.
Page 3
¤ • Mounting and wiring this product requires skills and experience. For safety’s sake, leave the mounting and wiring work to professionals. • Make sure to ground the unit to a negative 12V DC power supply. • Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity.
Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna.
Page 5
FUSE ( 15A ) REVERSE STEERING WHEEL REMOTE CONT REMOTE INPUT ILLUMI MUTE ANT. CONT P CONT GPS Antenna (Accessory 2) (see page 8) Accessory 1 White/Black White Gray/Black Gray Green/Black Green Purple/Black Purple To front left speaker To front right speaker To rear left speaker To rear right speaker English...
Installing the GPS Antenna (DNX SERIES only) GPS antenna is installed inside of the car. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. To mount the GPS antenna inside your vehicle: 1.
Installing the Escutcheon Installing the Escutcheon 1. Attach accessory 4 to the unit. For General Motors 1. Cut out accessory 5 to meet the shape of the opening of the center console. 2. Attach accessory 5 to the unit. Cut out to meet the shape of the opening in the vehicle.
Page 10
Installation for Monitor/Player Unit Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 7 (M5x6mm) or Accessory 8 (M5x7mm) DNX SERIES/ DDX SERIES Car Bracket Accessory 7 (M5x6mm) or Accessory 8 (M5x7mm)