3. Connect the wire on the wiring harness. 4. Take Connector B on the wiring harness and connect it to the speaker connector in your DNX7240BT only ..1 vehicle. 5. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle.
After the Installation • Reception may drop if there are metal objects near the Bluetooth antenna. After the installation, perform the Initial Setup by referring to the instruction manual. ¤ • Mounting and wiring this product requires skills and Bluetooth antenna unit experience.
Mute wire (Brown) Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. Power control/ Motor antenna control wire (Blue/White) Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle.
Bluetooth Microphone (Accessory 9) (DNX7240BT only) (see page 10) Cooling fan GPS Antenna (Accessory 7) (DNX7240BT only) (see page 10) FUSE ( 15A ) Accessory 1 REVERSE REMO.CONT MUTE ANT. CONT P.CONT English...
2 The A-7 pin (red) of the vehicle’s ISO connector is connected to the constant power supply, and the A-4 pin (yellow) is linked to the ignition. Ignition cable A-7 Pin (Red) (Red) Unit Vehicle Battery cable A-4 Pin (Yellow) (Yellow) DNX7240BT/DDX6054...
KCA-BT200 Connection cable (Optional Accessory) (Included in the KCA-BT200) 1 2 3 Type Switch Navigation System 1 2 3 (Optional Accessory) TV Tuner (Optional Accessory) Connection cable Connection cable (Included in the Navigation System) (Included in the TV tuner) DNX7240BT/DDX6054...
Installation for Monitor/Player Installing the Escutcheon Unit (DNX7240BT only) 1. Attach accessory 6 to the unit. Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Accessory 6 ⁄ Make sure that the unit is installed securely in place.
Installing the GPS Antenna Installing the Microphone Unit (DNX7240BT only) (DNX7240BT only) GPS antenna is installed inside of the car. It should 1. Check the installation position of the microphone be installed as horizontally as possible to allow easy (accessory 9).
Removing Monitor/Player Unit Removing the Hard Rubber Frame Removing the Unit (escutcheon) 1. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the 1. Engage the catch pins on the removal tool 5 and Hard Rubber Frame>.