Safety Precautions - Thermo Scientific Barnstead Smart2Pure 12 UV/UF Operating Instructions Manual

5. Safety precautions

Observe these safety precautions for your own safety!
 The Smart2Pure version that you have selected is a state-of-the-art ultrapure water
system, the intended purpose of which is to purify tap water of drinking water quality.
 Please do not start to install and operate the system until you have read through the
information that is given in these operating instructions.
 Please note that the use of the system for other than the intended purpose and/or im-
proper operation of it release the manufacturer from all liability.
 Lifting and carrying the ultrapure water system, e.g. to the installation location, should
be carried out by two people. To lift it, each takes hold of it under the base plate at two
corners.
The CE-mark is invalidated when constructional changes are made to the system or

foreign products are installed in it.
 Protect the system from frost. The temperature at the installation area must be at least
+ 2°C.
 Observe all general rules and regulations that are valid at the installation location, in-
cluding the relevant current accident prevention regulations.
 Feedwater pressure min. 1 bar and max. 6 bar. Should it be higher, then an additional
pressure reducer must be installed.
 According to DIN EN 1717, water purification systems must be equipped with a device
that safeguards the tap water against contamination.
 A suitable electric socket must be made available for the system (see Technical speci-
fications).
 The installation area must have a drain at floor level with at least DN 50 pipe and
which allows free run off.
 When the system is to be wall-mounted please check that the wall has sufficient load
bearing capacity (see Technical specifications for the weight).
Thermo Scientific Barnstead Smart2Pure
Ultrapure water system
9