Getting Started - Uniden BW2101 Owner's Manual

Getting Started (cont'd)
Installing the Camera on the Goose Neck Mount Stand
Use the goose neck mount stand to install the camera at an appropriate angle
in a semi-permanent (desktop mount option) or permanent (wall mount option)
location.
NOTE! Ensure the install location is within range of a 240VAC wall outlet.
locknut
Desktop mount option
1. Select the position for the camera
Wall mount option
1. Select the position for the mount
2. Mount the camera onto the bracket,
cord guides
3. Adjust the camera to the proper
4. Connect the AC adaptor and route
5. At the LCD monitor adjust the
7
and secure the camera stand.
stand and mark out the mount holes.
The two wall screws should be
spaced 40mm apart. Screws and
anchors are supplied, but if
necessary use an appropriate screw
type for the mounting surface.
but do not tighten.
view angle. Make sure the lens is
upright relative to your subject. Then
tighten the lock nut to secure the
camera.
the cord along the guides in the
stand.
antenna to an upright position.