Important Safety Instructions; Read And Save These Instructions; Setting Up The Cycle; Installation Requirements - Matrix MX-U5 Owner's Manual

R E A D A N D S AV E T H E S E I N S T R U C T I O N S
• This Cycle is intended to for commercial use
To insure your safety and protect the equipment, read all instructions before operating the
•
MATRIX Cycle.
When using an electrical product, basic precautions should always be followed, including
the following:
To reduce the risk of electric shock:
DANGER
• Always unplug this equipment from the electrical outlet immediately after using and
before cleaning.
Your MATRIX Cycle is self-generating (requiring no external power source) and must be ped-
aled to power up the console.
To reduce the risk of burns, fire, electrical shock or injury to persons that may be
WARNING
associated with using this product:
An appliance should never be left unattended when plugged in. Unplug from outlet when
•
not in use and before putting on or taking off parts.
This product must be used for its intended purpose described in this Owner's Guide. Do not
•
use other attachments that are not recommended by the manufacturer. Attachments may
cause injury.
To prevent electrical shock, never drop or insert any object into any opening.
•
Do not remove the side covers. Service should only be done by an authorized service technician.
•
Never operate the Cycle with the air openings blocked, Keep the air openings clean, free of
•
lint, hair and the like.
Never operate product if it has a damaged cord or plug, if it is not working properly, if it has
•
been damaged, or immersed in water. Return the appliance to a service center for examination
and repair.
Do not carry this appliance by supply cord or use cord as handle.
•
Keep any power cord away from heated surfaces.
•
Keep hands and loose clothing away from moving parts.
•
Close supervision is necessary when Cycle is used by or near children, invalids, or disabled persons.
•
• Do not use outdoors.
Do not operate where aerosol (spray) products are being used or where oxygen is being
•
administered.
To disconnect, turn all controls to the off position, then remove plug from outlet
•
Connect this Cycle to a properly grounded outlet only.
•
If you experience chest pain, nausea, dizziness or shortness of breath, STOP exercis-
CAUTION
ing immediately and consult a physician before continuing.

1) Important Safety Instructions

S E T T I N G U P T H E C Y C L E
Assembly instructions have been provided with your Cycle. For your safety, please read and fol-
low each of the steps in the assembly guide. To obtain a copy of the assembly guide, please
contact MATRIX FITNESS SYSTEMS.
1 . 1 I N S TA L L AT I O N R E Q U I R E M E N T S
Your MATRIX Cycle is designed to be self contained and does not require a power
supply to operate.
Fit Connexion TM requires a 9 volt battery and a 110 volt power supply to operate the monitor.
Use only the power supply provided by the manufacturer, please contact MATRIX FITNESS for
a replacement.
Use of the wrong power supply may cause damage to your Cycle and/or entertain-
CAUTION
ment device.
Locate a level stable surface to position Cycle. The Cycle has four leveling feet located under
the foot support. If your Cycle wobbles in the location where you intend to use it, loosen the
lock nut on the adjusting foot and adjust the feet until stable. Once level, lock the adjusting
feet by tightening the lock nut to the frame.
1 . 2 P R E V E N TAT I V E M A I N T E N A N C E A N D C L E A N I N G T I P S
Preventative maintenance and daily cleaning will prolong the life and look of your Matrix fit-
ness equipment.
Please read and follow these tips.
Position the equipment away from direct sunlight. The intense UV light can cause discoloration
•
of plastics.
Locate your equipment in an area with cool temperatures and low humidity.
•
Clean with a soft 100% cotton cloth.
•
Clean with non-ammonia based cleaners.
•
Wipe seats, handles, heart rate grips, and handlebars clean after each use.
•
Do not pour liquids directly onto your equipment. This can cause damage to the equipment
•
and in some cases electrocution.
Check pedal safety straps weekly for wear.
•
Adjust leveling feet when equipment wobbles or rocks.
•
Maintain a clean area around equipment free from dust and dirt.
•
1