Content Ingest Management Setup - GDC SX-2000 Installation Manual

5 Enter the projector IP address in the "Primary Projector IP" field and enable CineCanvas
by checking the box "Enable CineCanvas".
6 Select General -> IMB to check the Marriage/Service door tamper. Click Clear to clear
the Marriage/Service door tamper if a failure message appears (see Figure 25)
Once the IP for the projector has been configured you can proceed to defining projector macros.
For details please refer to Section 2.1.5 Automation Setup.

3.1.3 Content Ingest Management Setup

Content ingest management must be set up before the server is able to ingest content. This
section will show the setup for content ingest from two different sources. The same steps can
be used to set up content ingest sources using other methods.
GDC Technology Ltd.
SX-2000 Installation Manual
Figure 24 Cinecanvas setup screen
Figure 25 IMB status
11/8/2010
Page 21 of 42