Sx-2000 Configuration; Server Ip Setup - GDC SX-2000 Installation Manual

3.1 SX-2000 configuration

Note: The Series 2 projector has to be booted up and ready first before SX-2000A is powered
on. The indication of Series 2 projector being ready is that the three LED lights (OS, FMT, ICP)
should be constantly green and the LED light (SOFT) should be blinking green.

3.1.1 Server IP Setup

The IP address of the two network interface cards (NIC) on the SX-2000 server needs to be set
for proper operation. When configuring the NICs please keep in mind that eth0 is used for
projector communication and eth1 is used for the media network.
1 Click the power button once to access the [Control Panel]. You can also access the
Control Panel by selecting the [Control Panel] button from the SMS.
2 Click [Admin Panel] to access the Admin Panel Page.
3 Click [Focus] at the far bottom right of the keyboard, then click the cursor in the
"Password" text box to enter the password.
4 Select [Network]->[Network Setup]. This opens up a page displaying the Ethernet
connections of the two NICs. (eth0 is used to communicate with the projector and
eth1 is used for network access)
5 Highlight the NIC you wish to configure and click [Select] to view and change the
network configuration settings for this NIC. In this case, the NIC eth0 was chosen
(See Figure 22)
6 Once the settings have been entered, click [OK] and a small window will appear to
prompt you to "Restart network service". Click [OK] to confirm.
7 Repeat steps 5 and 6 to configure the other NIC.
GDC Technology Ltd.
SX-2000 Installation Manual
Figure 22 Network settings for eth0
11/8/2010
Page 19 of 42