GDC SX-2000 Installation Manual page 14

5. Select [Start] ->[Power] ->[On] to power on the projector.
6. After the projector has powered on successfully, the following steps must be taken
at the projector front panel:
a. Press and hold the Menu button until the front panel LCD prompts for a
password
b. Enter the Service user password using the channel buttons.
c. Select [Menu]->[Configuration] ->[Installation] ->[NewRouterSetup] and
select [Execute].
7. Clear the Service Door/Marriage Tamper on the server (refer to Section 3.1.2).
In order to use the IMB for content playback, the INPUT source of the projector macros must be
set to IMB.
2.5.3.3 Christie Series 2 Projector
When the IMB is installed into a Christie Series 2 projector, the following steps must be taken in
order for GDC server to playback with the Christie Series 2 projector:
Note: Ensure the projector is powered ON before proceeding.
1. Clear the projector's marriage tamper:
a. Log in to the "Marriage" account on the projector TPC. Select Menu->Service
Setup->Marriage to start the Marriage wizard (see Figure 16). Click the [Next]
button to proceed to the Marriage Checklist window.
GDC Technology Ltd.
SX-2000 Installation Manual
Figure 16 Projector marriage wizard on Christie projector TPC
11/8/2010
Page 13 of 42