is
3.11 Checking the supply
pressure and burner
pressure
Legend
Unused numbers are not applicable
1.
burner pressure regulator
2.
burner pressure regulator
cap
3.
burner pressure regulator
adjusting screw
4.
gas control connector
5.
blank plate
6.
supply pressure nipple
7.
gas control
8.
manifold test nipple
Instruction manual CHA
Comment
Before starting the appliance and/or checking the supply pressure and
burner pressure, you must fill
Note
Before starting up for the first time or after conversion, you must always
check the supply pressure and burner pressure.
Comment
The easiest way to check the gas pressures is by using two pressure
gauges. This procedure assumes that these two gauges are available.
Gas control for CHA 100 to 600
6
7
(5 "Filling")
the appliance.
4
1
3
5
8
2
IMD-0127 R1
29