Table of Contents
Advertisement
Signal Booster Installation
1.
Select a location for the Signal
Booster that is away from excessive
heat, direct sunlight, moisture and
well ventilated. The enclosure must
NOT be air tight. Also, be sure the
location is near a power source.
2.
Connect the coax cables to the
Signal Booster from the Outside
Antenna and Inside Antenna at the
designated ports.
3.
Do NOT connect the Signal Booster
to the power source until all cables
are connected.
Inside Antenna Installation
1.
Select a location in the center of
the area where you want cellular
signals improved to mount the Inside
Antenna. If you have multiple rooms
with poor signal, you may need
multiple Inside Antennas. These
can attach to the Signal Boost by
using a splitter (sold separately).
Contact Wilson Electronics for more
information.
2.
Ensure a minimum of 20 feet vertical
or 50 horizontal feet separation from
the Outside Antenna.
6
Need help?
Outside Directional
Antenna
Place the inside antenna
directly beneath the
placement of the Outside
Antenna location
At least 20 feet of vertical or
50 horizontal separation
Inside Panel Antenna
www.WilsonElectronics.com
3.
Inside Antennas can be mounted
above ceiling drywall, on a ceiling
inside a room, or on a wall inside a
room. Ensure the Inside Antenna
is facing AWAY from the Outside
Antenna to avoid oscillation
(feedback).
4.
Use the mounting hardware included
in the package to secure the Inside
Antenna to the selected location.
Powering Up The Signal
Booster
1.
Ensure the cables to both the Outside
Antenna and Inside Antenna are
securely connected before powering
up the Signal Booster.
2.
Plug the power supply into the Signal
Booster input marked "POWER" and
then into a surge protector power strip
with a minimum 1000 Joule rating.
!
3.
The lights on the Signal Booster
should remain green . If the
lights are red or orange, see the
"Troubleshooting" section on page 6.
4.
If you know that only one frequency
band is available in your coverage
area, reduce the gain control on the
frequency band that is NOT in use
to the lowest setting. This will reduce
power consumption of the Signal
Booster.
For illustrations of these installation steps,
view the install video at wilsonelectronics.
com/DBPro4Gvideo.
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
Face inside
antenna
away from
the outside
antenna.
Inside
Antenna
Hide quick links:
Advertisement
Table of Contents
