Signal Booster Specifications - Wilson Electronics DB Pro 4G User Manual

Cellular signal booster

Hide thumbs Also See for DB Pro 4G:

Installation instructions manual (23 pages)

Table Of Contents

Table of Contents

Signal Booster Specifications

Model Number

Antenna connectors

Antenna impedance

Dimensions

Weight

Frequency

Power output for a single phone (uplink) dBm

Power output for a single received channel (downlink) dBm

Noise Figure (typical downlink/uplink)

Isolation

Power Requirements

Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or

disabling the hardware. The Signal Booster will amplify, but not alter the incoming and outgoing signals in order to increase coverage of authorized frequency

bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band,

or if the Signal Booster detects and oscillation, the Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal

Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such restarts, any problematic bands are permanently shut

off until the Signal Booster has been manually restarted by momentarily removing the power from the Signal Booster. Noise power, gain, and linearity are

maintained by the Signal Booster's microprocessor.

To Outside

Antenna

Lightning

Surge Protector

(sold separately)

To Signal Booster

Need help?

RECOMMENDED: INSTALLING THE LIGHTNING SURGE PROTECTOR

(SOLD SEPARATELY)

INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL

BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE