Table of Contents
Advertisement
Changing the System
Configuration
Even after configuring the system, you can add new cameras
and remove or replace registered cameras.
Caution:
● Never turn off the power while saving settings of
Management Application.
● When you change settings, restart the Management
Application service; otherwise, the new settings are not
applied.
Manually Registering a Camera
Cameras not automatically detected or newly installed
cameras may be registered on the system manually by
entering the IP address and port.
Caution:
● A user name and password is required for camera
registration. Be sure to confirm beforehand. For details,
see the instruction manual of the camera.
● Cameras with restricted user access may not be
registered. For more information about the access
restrictions, see the instruction manuals of the respective
cameras.
1
Double-click [Management Application] on the
desktop
2
Click [Add a Hardware Devices...]
3
Select [Manual] and click [Next]
4
Click [Use]
5
Enter the address, port number, user name, and
password for the camera to add and click [Next]
Camera verification starts.
When verification is complete, a summary of the added
camera (hardware device) appears.
Note:
● For the registered device, a name such as "Camera 1,"
"Camera 2," etc. will be assigned names automatically
according to the device type (camera, microphone, etc.)
and the added order number. Click on a device name to
edit it.
● In the case that a camera cannot be verified, please
confirm the user name and password. If the user name for
the camera has been changed, it is possible to verify by
resetting the user name and selecting [default]. If it can
still not be registered, click [Back] and confirm whether the
driver for the camera is displayed on the pull-down menu
of [Hardware Drivers].
115
Advertisement
Table of Contents
