Checking The Operating State - Siemens Giga762SX User Manual

First steps
ì
Choose the encryption method WPA2-PSK/ WPA-PSK in the configuration settings of
your network adapter and enter the pre-shared key of you Giga762SX WLAN dsl.
If one of your network adapters do not provide this encryption method, you must
change the encryption method at the Giga762SX WLAN dsl (see page 88) and then
configure the encryption appropriatly for all network adapters. The settings at the
Giga762SX WLAN dsl should be performed only with a wired connected PC)
If the correct SSID and encryption has been entered in your PC's wireless network
adapter, the wireless link will be established automatically.

Checking the operating state

Your Giga762SX WLAN dsl is now ready for use. The LED displays on the front panel of
the Giga762SX WLAN dsl provide information about the operating state (see page 22).
When the device is ready for use, the LEDs light up as follows:
u
The Power LED on the front lights up.
u
The ADSL LED flashes to indicate that the DSL connection is being synchronised.
Once this process is complete, the ADSL LED lights up permanently.
u
The WLAN LED lights up to indicate that the Giga762SX WLAN dsl is ready to estab-
lish wireless connections.
The radio link to a PC that is connected by means of a wireless network adapter is
opened automatically provided the network adapter has been configured with the
same SSID as the Giga762SX WLAN dsl. It can take a few seconds for the wireless
connection to be established. The WLAN LED flashes when data is sent or received
via this connection.
u
The LAN LEDs light up if a device is connected to the corresponding LAN port.
If this is not the case, refer to the section entitled Troubleshooting on (page 157).
34
(((
WLAN adapter