Checking The Operating State - Siemens Gigaset SX763 WLAN dsl Manual

A wireless network is defined by assigning an identical SSID to all the devices.
ì
You should therefore enter the SSID for the Gigaset SX763 WLAN dsl in your network
adapter configuration. The default SSID for the Gigaset SX763 WLAN dsl is
ConnectionPoint.
If you use a wireless network adapter from the Gigaset range, enter the SSID using
the Gigaset WLAN Adapter Monitor.
If the correct SSID has been entered in your PC's wireless network adapter, the wireless
link will be established automatically.

Checking the operating state

Your Gigaset SX763 WLAN dsl is now ready for use. The LED displays on the front panel
of the Gigaset SX763 WLAN dsl provide information about the operating state (see
page 23).
When the device is ready for use, the LEDs light up as follows:
The Power LED on the front lights up.
u
The ADSL LED flashes to indicate that the DSL connection is being synchronised.
u
Once this process is complete, the ADSL LED lights up permanently.
The WLAN LED lights up to indicate that the Gigaset SX763 WLAN dsl is ready to
u
establish wireless connections.
The radio link to a PC that is connected by means of a wireless network adapter is
opened automatically provided the network adapter has been configured with the
same SSID as the Gigaset SX763 WLAN dsl. It can take a few seconds for the wireless
connection to be established. The WLAN LED flashes when data is sent or received
via this connection.
The LAN LEDs light up if a device is connected to the corresponding LAN port.
u
If this is not the case, refer to the section entitled Troubleshooting on (page 164).
(((
WLAN adapter
First steps
35