Siemens Giga762SX User Manual page 123

ì
You can change the Port via which you can access the configuration program from
the Internet, for example in order to mask and protect the configuration program
against unauthorised access.
ì
Access: You can select Read only if you only wish to activate remote management
for reading or you can select Full control if you wish to activate it for reading and
writing.
ì
Allowed connections: You can specify one particular PC or specify a range of IP
addresses of clients for Remote Management or you can activate this function for
any PC.
Please remember:
If you permit several PCs then anyone who finds out your password can access this
user interface and therefore also your network! If it is needed, then you should
only activate this option for a short time.
– Select the required option from the list.
– For the option Only specified client, enter the IP address of the client, or the first
and last IP address in the range you want to permit.
Please remember:
u
The Internet provider may assign the IP address to the PC dynamically. This may
change the IP address. Make sure that the PC that is to access the router from
the Internet always has the same IP address.
u
For access to the configuration environment via Remote Management, you
must enter the address of the Giga762SX WLAN dsl to be managed in the
browser using the following format: http://X.X.X.X:8080
(x.x.x.x represents the IP address of the Giga762SX WLAN dsl).
ì
If you have defined more than one Connection service (see page 62), choose from
the list the Connection service, for which you want configure Remote Manage-
ment.
ì
Click OK to accept the settings.Registration button
If your device is equipped with a hardware registration button (Scan button) for WPS
registration (see page 25), you can deactivate this button for security reasons.
ì
Click disabled to deactivate the WPS hardware registration button.
ì
Click OK to accept the settings.
Administration
125