Connecting Wires To Terminals - Kenwood eXcelon KDC-X789 Instruction Manual

Connecting Wires to Terminals

A
KDC-X979/ Subwoofer right output
X789/MP828/ (Red)
MP7028
Subwoofer left output
(White)
KDC-MP728/
Rear right output (Red)/
MP628 Subwoofer right output (Red)
Rear left output (White)/
Subwoofer left output (White)
To KENWOOD disc changer/
External optional accessory
To connect these leads,
refer to the relevant
instruction manuals.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect
to its power control terminal.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna,
or to the power terminal for the booster amplifier of
the film-type antenna.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To "EXT.AMP.CONT. " terminal of the amplifier having
the external amp control function.
Car fuse box
(Main fuse)
B
Rear right output
(Red)
Rear left output
(White)
Fuse (10A)
To car light control switch
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker
Ignition key
switch
–
+
Battery
Power control wire (Blue/White)
P.CONT
ANT.
Motor antenna control wire
CONT
(Blue)
TEL mute wire (Brown)
MUTE
External amplifier control wire
(Pink / Black) (KDC-X889/X789 only)
Dimmer control wire (Orange
/ White)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
ACC
Car fuse box
Ground wire (Black) · (To car chassis)
A
B
Front right output (Red)
FRONT
Front left output (White)
AUX right input (Red)
AUX IN
AUX left input (White)
FM/AM antenna input
FRONT • L
FRONT • R
REAR • L
REAR • R
Ignition wire (Red)
Battery wire (Yellow)
Wiring harness
(Accessory1)
55
|
English