Dual Zone System Setting; Bass Management System); B.m.s. Frequency Offset - Kenwood eXcelon KDC-X789 Instruction Manual

• Do not use G-Analyzer stop watch on the Public roads.
1
Select G-Analyzer Stop Watch mode
Push the Control knob to [FM] or [AM].
Select the "Stop Watch" display.
2
Enter G-Analyzer Stop Watch mode
Press the Control knob for at least 1 second.
"Stop" is displayed.
3
Enter Counter Ready mode
Press the Control knob.
"Ready" is displayed.
4
Start Count
When G on the vertical direction is detected
during the traveling, the count is automatically
started.
"Running" is displayed.
• You can also start the counter by pressing the Control
knob.
5
Stop Count
Press the Control knob.
"Stop" is displayed.
• The control will be started again when you accelerate
or press the Control knob.
Do the operation after step3.
When you Reset the Count
(While "Stop" is displayed)
Press the Control knob for at least 2 seconds.
• The reset of count can be done when the count is
stopped.
6
Exit G-Analyzer Stop Watch mode
Press the [MENU] button.
• When "Running" is displayed (counted), the count is
continued on although G-Analyzer Stop Watch mode
is finished. If you want to stop the count, enter the
menu mode then press the control knob.
• When Power off (ex; ACC OFF) while counting, the
value of 1 second or less will be "00".
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel
sound in the Dual Zone System.
Display Setting
"Zone 2 : Rear" Sub source (Auxiliary input source) is to be rear
channel.
"Zone 2 : Front" Sub source (Auxiliary input source) is to be front
channel.
Function of the KDC-X889/KDC-X789
Other than Standby mode
B.M.S. (Bass Management System)
Adjust the bass boost level of the external
amplifier using the main unit.
Display Setting
"AMP Bass : Flat" Bass boost level is flat.
"AMP Bass : +6" Bass boost level is low (+6dB).
"AMP Bass : +12" Bass boost level is mid (+12dB).
"AMP Bass : +18" Bass boost level is high (+18dB).
• Refer to the catalog or instruction manual for power
amplifiers that can be controlled from this unit.
• For amplifiers there are the model that can be set
from Flat to +18 dB, and the model that can be set
from Flat to +12 dB.
When an amplifier that can only be set to +12 is
connected to the unit, "AMP Bass : +18" won't work
correctly even if it's selected.
Function of the KDC-X889/KDC-X789
Other than Standby mode

B.M.S. Frequency Offset

Setting the central frequency boosted by B.M.S.
Display Setting
"AMP FREQ : Normal" Boost with the normal central frequency.
"AMP FREQ : Low" Drop the normal central frequency 20%.
45
|
English