Display Mode Switching; Graphic Part/ Spectrum Analyzer Display - Kenwood eXcelon KDC-X789 Instruction Manual

General features

Display Mode Switching

Switching the display mode.
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [6] (KDC-X889/MP828)/[2]
(KDC-MP7028/MP728/X789/MP628) button.
Refer to <Notes on Multi-function Key System>
(page 9).
2
Enter display control mode
Press the [6]/[2] ("DISP") button.
3
Select the display mode
Press the [1] ("MODE") button.
4
Select the display Type
Push the Control knob to [4] or [¢].
Each time the knob is pushed, the display mode
switches as shown below.
Display Mode Display
"Display Type A" 1
"Display Type B"
1
"Display Type C"
3
3
3
"Display Type D"
8
"Display Type E"* 9
1 Graphic display part
2 Text display part
3 Text icon display part
4 Upper text display part
5 Middle text display part
6 Lower text display part
7 Source icon display part
8 Function item display
9 G-Analyzer display part
20
|
English
2
4
5
6
4 7
6
8 8 8 8 8
• * Function of the KDC-X889/MP828/MP7028/MP728/
X789
5
Exit display control mode
Press the [6] ("RTN") button.
• Under the display type other than "Display Type D",
the function item is not displayed. When the display
type other than "Display Type D" is selected, press [1]
to [6] buttons or [NEXT] button. The function item will
be displayed approximately 5 seconds.
• The information can be switched by the Display
Type. Refer to the page on the following table for the
methods to switch by the Display Type.
Display Type A
Graphic 1
20
Text 2
—
Upper 4
—
Middle 5
—
Lower 6
—
G-Analyzer 9
—
Display Type A/ Display Type B
Graphic part/ Spectrum Analyzer
Display Switching
Switching the graphic Display/ Spectrum analyzer
display.
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [6] (KDC-X889/MP828)/[2]
(KDC-MP7028/MP728/X789/MP628) button.
Refer to <Notes on Multi-function Key System>
(page 9).
2
Enter display control mode
Press the [6]/[2] ("DISP") button.
3
Select the display mode
Press the [1] ("MODE") button.
4
Select the display Type
Push the Control knob to [4] or [¢].
Select the "Display Type A"/ "Display Type B"
display.
B C D E
— — —
20
22 — — —
— 23 23 —
— 23 — —
— 23 23 —
— — — 27