Audio Preset Call; Demonstration Mode Setting - Kenwood eXcelon KDC-X789 Instruction Manual

Menu system
Function of the KDC-MP7028/KDC-MP728/KDC-
X789/KDC-MP628
Other than Standby mode

Audio Preset Call

Recalling the sound setup registered by <Audio
Preset Memory> (page 49).
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"Menu" is displayed.
3
Select Audio Preset mode
Push the Control knob to [FM] or [AM].
Select the "Audio Preset" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Call
Push the Contol knob to [FM] or [AM].
Select the "Call" display.
6
Call up the Audio Preset
Press the Control knob for at least 2 seconds.
The "Call" display blinks 1 time.
7
Exit Menu mode
Press the [MENU] button.
• The User memory of <Equalizer Control> (page 16) is
changed to the value which was recalled.
• The source tone memory item of <Audio Control>
(page 10) is changed to the value which was recalled
by the selected source.
50
|
English
In Standby mode

Demonstration mode Setting

Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob to [FM] or [AM].
Select the "DEMO Mode" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time the knob is pressed at least 2 seconds,
the Demonstration mode switches as shown
below.
Display Setting
"DEMO Mode : ON" The Demonstration mode function is ON.
"DEMO Mode : OFF" Exit Demonstration mode (Normal mode).