NetComm NTC-140W Series Quick Start Manual page 14

Connecting the NTC-140W Series router to another access point
To use your NTC-140W router as a client, you must first change the wireless mode
on the web user interface. To enable the wireless client:
1. From the top menu bar, select the Networking option.
2. Select Wireless settings on the left, then select the Client configuration
menu item.
3. Click the Client radio on/off toggle key so that it is in the ON position then
click the Save button.
4. On the Client configuration page, click the Scan button to scan for remote
access points to connect to, then click the Connect link corresponding to
the desired network. The wireless network's details are copied to the Client
configuration fields.
5. If the network requires a password, enter the password in the WPA pre-
shared key field, then click the Save button. The wireless client connects to
the access point. You can confirm that it is connected by viewing the WLAN
client connection status section of the Status page. For further detail on
using the wireless client, refer to the product user guide.
14