Connecting Wires To Terminals - Kenwood KDC-BT645U Instruction Manual

Connecting Wires to Terminals

AUX input (Stereo)
Use the mini-plug cable which is stereo type and
does not have any resistance.
Fuse (10A)
Wiring harness
(Accessory1)
Power control/Motor antenna control wire
(Blue/White)
Mute control wire (Brown)
Steering remote control
(Light Blue/Yellow)
Not used (Blue)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
36
|
KDC-BT645U/ KDC-HD545U
USB connector
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal when using the optional
P.CONT
power amplifier, or to the antenna control terminal in the vehicle.
To connect the Kenwood navigation system, consult your navigation
manual.
MUTE
⁄
To use the steering wheel remote control feature, you need to an
REMOTE CONT
exclusive remote adapter (not supplied) matches your car is required.
STEERING WHEEL
REMOTE INPUT
ANT. CONT
Car fuse
box
ACC
R L
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant
instruction manuals.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Connect to the terminal that is grounded when either the
telephone rings or during conversation. (KDC-HD545U only)
Ignition key
switch
Car fuse box
(Main fuse)
Battery
– +
FM/AM antenna input
Rear output
Front output
Sub Woofer output