ENFORCER MVE-WH010Q Installation Manual

Wireless hdmi extender

MVE-WH010Q

Wireless HDMI Extender

Installation Manual

 Wirelessly transmits HDMI from a source to a monitor up to 98ft (30m)

 Support resolutions up to 1080p

 Signal can pass through walls

 IR pass-through for remote control support

NOTE: Products with model numbers that end with "Q" or products that have a round green "Q" sticker signify RoHS compliance.

Table of Contents

Need help?

Do you have a question about the MVE-WH010Q and is the answer not in the manual?

Page 1 MVE-WH010Q Wireless HDMI Extender Installation Manual  Wirelessly transmits HDMI from a source to a monitor up to 98ft (30m)  Support resolutions up to 1080p  Signal can pass through walls  IR pass-through for remote control support NOTE: Products with model numbers that end with “Q” or products that have a round green “Q” sticker signify RoHS compliance.
Page 2: Specifications
ENFORCER Wireless HDMI Extender Specifications: Transmitter Transmission frequency 5.1~5.9GHz Frequency stability 4PPM Bandwidth 40MHz Transmission power >12dBm Receiving sensitivity <-75dBm System latency <1ms Power supply 5VDC Current draw 2A / Dimensions ” x 3 ” x ” (148 x 97 x 18mm) Weight 15.5oz (440g)
Page 3 ENFORCER Wireless HDMI Extender Overview: Base included for attractive, Transmitter: convenient installations. If using the base, always install Antenna with the antenna end up. IR Remote signal output Status indicators HDMI Input Power input Reset button Receiver: Antenna Status indicators...
Page 4: Troubleshooting
ENFORCER Wireless HDMI Extender Troubleshooting  Make sure the transmitter and receiver are connected to power.  Reset the receiver and transmitter. Use a pencil or small object to hold the reset button of the receiver down for 3 seconds.