ENFORCER MVE-AH030AQ User Manual

Basic hdmi extender over single cat5e/6

Table of Contents

Download this manual

Basic HDMI Extender over Single Cat5e/6

• Extend HDMI over a single Cat5e/6

cable

• Supports resolutions from 480i to 1080p

with zero signal loss

• Transmits up to 196ft (60m) at 1080p

over Cat5e/6 cable

IMPORTANT: This product is designed to extend an HDMI signal over Cat5e/6. This

product is not to be used to bypass any copy protection or other content protection system.

All usage of this product shall conform to the license that comes with the content.

MVE-AH030AQ

Manual

Up to

196ft

Cat5e/6

(60m)

Single Cable

1080p Resolution

• Plug and play operation – comes as a

complete set

• Bi-directional IR for remote control

extension

• EDID management setting

• Two (2) 5VDC power supplies included

Plug

and

Play

Operation

Table of Contents

Need help?

Do you have a question about the MVE-AH030AQ and is the answer not in the manual?

Page 1 ® MVE-AH030AQ Basic HDMI Extender over Single Cat5e/6 ® Manual Up to Plug 196ft Cat5e/6 Play (60m) Single Cable Operation 1080p Resolution • Extend HDMI over a single Cat5e/6 • Plug and play operation – comes as a cable complete set •...
Page 2 ENFORCER Basic HDMI Extender over Single Cat5e/6 Introduction: The ENFORCER Basic HDMI Extender over Single Cat5e/6 extends the range of traditional HDMI cabling methods by using an active transmitter and receiver to send video and audio over a single Cat5e/6 cable.
Page 3 IR Tx Installation: 1. Determine the locations where the MVE-AH030AQ units will be wired as well as how much Cat5e/6 cable is necessary. 2. Connect the transmitter to the HDMI output of the source device. 3. Connect the Cat5e/6 cable to both the receiver and transmitter units.
Page 4 ENFORCER Basic HDMI Extender over Single Cat5e/6 Troubleshooting: • Use T568-B wiring standard. • Make sure the extender is powered on both sides. • Make sure the source and display are powered. • Test the Cat5e/6 cable between the received and the HDMI device does not function correctly transmitter to make sure it is functional.