ENFORCER HDMI Extender over IP
Changing the IP and MAC Address Continued:
and MAC Address Continued:
4. Select "System Settings" and change the last segment of the IP address shown to a unique
Select "System Settings" and change the last segment of the IP address shown to a unique
number between 1 and 254.
5. Change the final digits of the MAC address from the default
Change the final digits of the MAC address from the default (TX: 00:0b:78:00:60:01,
RX: 00:0b:78:00:60:02) to a unique hexadecimal number between 01 and FF.
to a unique hexadecimal number between 01 and FF.
6. Click "Apply" to enable the changes.
7. Repeat for each additional TX/RX and then install as described in "Installation" on pg. 4 and
consult the diagrams on pgs. 5-6 as necessary.
Also Available from SECO-LARM:
MVE-AH010Q
HDMI Extender over Dual
HDMI Extender over Single
HDMI Extender over Single
Cat5e/6
MVS-AH31-01NQ
MVS-AH51-01NQ
4K HDMI Switchers
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing
Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing
LLC in the United States and other countries.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal
LARM product is warranted against defects in material and workmanship while used in normal
service for the one (1) year from the date of sale to the original customer. SECO
from the date of sale to the original customer. SECO-LARM's obligation is limited to the repair
or replacement of any defective part if the unit is returned, transportation prepaid
ve part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO
nstallation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship.
SECO-LARM and the purchaser's exclusive remedy shall be limited to the replacement or repair only, at SECO
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO
LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is not responsible for misprints. Trademarks are
the property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
®
U.S.A., Inc.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Tel: (949) 261-2999 | (800) 662-0800
8
described in "Installation" on pg. 4 and
MVE-AH030Q
High-Speed
HDMI Cables
Cat5e/6
MVD-AH12-01Q
MVE-AH030AQ
MVD-AH14-01Q
Basic HDMI Extender over
MVD-AH18-01Q
Single Cat5e/6
4K HDMI Splitters
s
s in material and workmanship. The sole obligation of
limited to the replacement or repair only, at SECO-LARM's
LARM is not responsible for misprints. Trademarks are
Website: www.seco
Website: www.seco-larm.com
Email: sales@seco
Email: sales@seco-larm.com
MI_MVE-AHMPM-01NQ_160426.docx
SECO-LARM U.S.A., Inc.
HDMI
• Extends HDMI over one Cat5e/6 cable or
IP network
• Supports One-to-One, One-to-Many, and
Many-to-Many applications
• Supports cascaded installation
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United
States and other countries.
PICSN6
MVE-AHMPM-01NQ
®
Extender Over IP
Manual
• IR Support (38kHz~56kHz)
• HDCP Compliant
• Transmitter (MVE-AHMPM-01NTQ) and
receiver (MVE-AHMPM-01NRQ) also
available separately
Support
Need help?
Do you have a question about the MVE-AHMPM-01NQ and is the answer not in the manual?
Questions and answers