Mendota DT3-PF2-LX Operating Instructions Manual page 30

F
18. Identify Log "G" and locate the hole at
its bottom surface. Log "G" will be
installed on the left side of the fireplace,
with the hole on the bottom of the log
setting on the left pin in log "D".
29
E
HOLE IN LOG
"G" IS
LOCATED
UNDER HERE!
19.
G
20.
H
21.
HOLE
Log "H" front
tip sits on flat
crimp of front
burner
16. Identify Log "E" and Log "F". Log "E" rests on left side of
the T-propagation tube . Log "E"'s left edge rests against
the front burner inlet tube, at floor level.
17. Log "F" sits on the firebox floor and against the left side
of the inlet tube on the front burner. Push this log back
as far as possible.
NOTCH
The front end of log
"G" is notched. The
notch will rest on the
left-most grate bar.
Identify Log "H". Log "H" will be installed on the
right side of the fireplace, with the hole on the
bottom of the log setting on the right pin in log "D".
The front end of log "H" will be resting to the right
end of the front burner tube as shown.
HOLE IN
Log "G" position on front grate
LOG
"H".