Lcd Display - Daikin AGZ 025D Operating & Maintenance Manual

LCD Display

Table 16, Display Data
No Name
Operation
1
Mode Menus
DriveWorksEZ
2 Function
Selection
Mode Display
3
Area
4 Ready
5 Data Display
FrequencyRef
erence
6
Assignment
<1>
LO/RE Display
7
<2>
Function Key
8
1(F1)
9 FWD/REV
Function Key 2
10
(F2)
62
Display
Displayed when in Mode Selection.
MODE
Displayed when in Monitor Mode.
MONITR
VERIFY Indicates the Verify Menu
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
DWEZ Displayed when DriveWorksEZ is set to enable. (A1-07 = 1 or 2)
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode
Rdy Indicates the drive is ready to run.
—
Displays specific data and operation data.
Displayed when the frequency reference is assigned to the LCD Operator
OPR
Option.
Displayed when the frequency reference is assigned to the Analog Input of the
AI
drive
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus
COM
CommunicationInputs of the drive
Displayed when the frequency reference is assigned to an Option Unit of the
OP
drive.
Displayed when the frequency reference is assigned to the Pulse Train Input of
RP
the drive
RSEQ Displayed when the run command is supplied from a remote source.
LSEQ Displayed when the run command is supplied from the operator keypad.
RREF Displayed when the run command is supplied from a remote source.
LREF Displayed when the run command is supplied from the operator keypad
JOG Pressing [F1} executes the Jog function.
Pressing [F1] displays the Help menu.
HELP
←
Pressing [F1] scrolls the cursor to the left.
Pressing [F1] returns to the top menu (Frequency Reference).
HOME
ESC Pressing [F1] returns to the previous display
FWD Indicates forward motor operation.
REV
Indicates reverse motor operation.
FWD/REV Pressing [F2] switches between forward and reverse
DATA Pressing [F2] scrolls to the next display
Pressing [F2] scrolls the cursor to the right
RESET Pressing [F2] resets the existing drive fault error
AGZ 025D through 190D
Content
OMM 1166-1