Daikin AGZ 025D Operating & Maintenance Manual page 63

Table 17, Alarm Content
State
Illuminated
Flashing
Off
Table 18, LO/RE LED and RUN LED Indictors
LED
When the operator
is selected for Run
command and
frequency
reference control
(LOCAL)
During run
Examples
OMM 1166-1
Content
When the drive detects an alarm or error
When an alarm occurs
When an oPE is detected
When a fault or error occurs during Auto-Tuning
Normal operation (no fault or alarm)
Lit Flashing Slowly
--
 During
deceleration to
stop
 When a Run
command is input
and frequency
reference is 0 Hz
AGZ 025D through 190D
Flashing Quickly
--
 While the drive was set to
LOCAL, a Run command
was entered to the input
terminals then the drive was
switched to REMOTE.
 A Run command was
entered via the input
terminals while the drive was
not in the Drive Mode.
 During deceleration when a
Fast Stop command was
entered.
 The drive output is shut of by
the Safe Disable function.
 The STOP key was pressed
while drive was running in
REMOTE.
 The drive was powered up
with b1-17 = 0 (default) while
the Run command was
active.
Display
Off
When a device other
than the operator is
selected for Run
command and
frequency reference
control (REMOTE)
During stop
63