Table of Contents
Advertisement
5.9.2
Power-Off Timeout
If this command is enabled, after the desired timeout in hours, the Dragon™ batteries
are disconnected and all power consumption ceases. To restore power, press the
trigger once. The reader will now be ready to read codes.
Power-off does not affect configuration parameters.
5.9.3
Transmission Mode
This parameter determines whether the reader receives responses or messages from
the Host or not. In One-Way tx mode, neither Host nor cradle responds to the reader.
In Two-Way tx mode, the reader must receive a response from either the cradle or
the Host.
The cradle responds (empty message) to the reader, only after good transmission to
the Host, for the following conditions: ACK/NACK enabled, see par. 5.1.2; WEDGE or
PEN interface. For these conditions, it is suggested to prolong the Radio Protocol
Timeout, see par. 5.9.1.
Enabling Two-Way tx mode temporarily disables FIFO buffering see par. 5.1.3.
REFERENCES
159
Hide quick links:
Advertisement
Table of Contents
