Beeper Control For Radio Response; Single Store - Datalogic Dragon D131 Reference Manual

DRAGON™ D131/M131
With ACK/NACK disabled, the Host responds to the reader (through the cradle) with
an answer message (message to reader display or command to reader), see par. 6.1
and the following figure.
Transmission Mode = Two-Ways
DRAGON™ M
Host answer
message
5.9.4

Beeper Control for Radio Response

For M131 series readers, the data entry good read tone normally results in two
beeps; the first indicates that the reader has decoded the code, the second indicates
whether OM-30X0 has received the data.
This can be changed according to the following selections:
♦ Normal: both good decode and good reception are signaled (two beeps).
♦ Only Good Decode: only the first beep indicating a good read is signaled.
♦ Only Good Reception: only the second beep indicating a good reception is
signaled.
♦ Off: Neither good read nor good reception beeps are signaled.
For all configurations, any transmission errors will always be signaled.
5.9.5

Single Store

When single store mode is enabled, if the Dragon™ M131 fails to transmit a code to
the cradle, it enters a special operating mode that prevents the user from reading
barcodes. When such operating mode is entered, the trigger no longer enables
barcode reading but is used to retry transmission itself for the number of attempts
selected in configuration. Once the transmission is successful the reader returns to
the standard mode. If transmission is not successful after the number of configured
attempts, the code is discarded.
Single store may be useful if you often read codes at the limit of the coverage area
and there is a chance that code transmission can fail. In such case single store
allows you to move to a more favorable position or location (i.e. closer to the cradle)
and retry transmission without the necessity of re-reading the code since it is already
stored in the reader.
160
data
OM-30X0
data
cable
Host answer message
Host