Datalogic Dragon D131 Reference Manual page 13

INSTALLATION
Follow the given procedure for correct cable insertion:
Align
Align
5
2
3
4
6
7
1
Slip the cover over the cable.
Push the rubber boot completely over the connector. Take care that the rubber
boot mark is aligned to the connector clip.
Pull the rubber boot towards the connector until it covers and is flush with the
connector moulding.
Lock the rubber boot clip around the rubber boot aligning them as shown in the
figure.
Insert the assembly (connector + rubber boot locked through clip) into the reader
connector. Push the cover along the cable towards the reader handle and make it
hook over the yellow tooth therefore closing the handle.
Insert the strain relief into the cover.
Insert the screw into the strain relief and tighten to fix the whole assembly to the
reader handle.
Connections should always be made with power OFF!
CAUTION
3