Configuration Of P2P Connections - Lancom L-54g Wireless Manual

LANCOM L-54g Wireless - LANCOM L-54ag Wireless - LANCOM L-54 dual Wireless
Once signal monitoring has commenced, the P2P dialog displays the absolute
values for the current signal strength and the maximum value since starting
the measurement. The development of the signal strength over time and the
maximum value are displayed in a diagram, too.
Initially only one of the two antennas should be adjusted until a maximum
value is achieved. This first antenna is then fixed and the second antenna is
then adjusted to attain the best signal quality.
5.2.3

Configuration of P2P connections

In the configuration of point-to-point connections, entries have to be made
for the point-to-point operation mode, the channel selection scheme and the
MAC addresses of the remote sites.
Configuration with For configuration with LANconfig you will find the settings for P2P connec-
LANconfig
tions under the configuration area 'Interfaces' on the 'Wireless LAN' tab.

Are both antennas approximately aligned? The basic P2P connection has
to be working before fine-tuning can be performed with the aid of
LANmonitor.
The configuration of the P2P connections can also be carried out with
the WLAN Wizards in LANconfig.
Click on the button Physical WLAN settings to open the corresponding
WLAN interface and select the tab for 'Point-to-Point'.
Activate the suitable point-to-point operation mode here and set the
channel selection scheme to either 'Master' or 'Slave'. If the peers of the
Chapter 5: Advanced wireless LAN configuration
55