Instructions For Lanconfig - Lancom L-54g Wireless Manual

LANCOM L-54g Wireless - LANCOM L-54ag Wireless - LANCOM L-54 dual Wireless
If no other access points are operating within the access point's range, any
radio channel can be set. Otherwise the channels in the 2.4 GHz band must
be selected in such a way that they do not overlap and are as far apart as pos-
sible. In the 5 GHz band the automatic setting, where the LANCOM Access
Point uses TPC and DFS to select the best channel is normally sufficient.
Please refer to the LCOS reference manual for more information on

TPC and DFS.
3.2

Instructions for LANconfig

Start up LANconfig by clicking Start
LANconfig. LANconfig automatically detects the new LANCOM devices in
the TCP/IP network.
If an unconfigured device is being found during searching, the setup
wizard starts that will help you make the basic settings of the device or
will even do all the work for you (provided a suitable network environment
exists).
If the setup wizard does not start automatically, start a manual search

for new devices on all ports (if the LANCOM is connected via a serial
port) or in the network (Device
If the setup wizard does not start automatically, start a manual search

for new devices in the network (Device
If you cannot access an unconfigured LANCOM, the problem may be

due to the netmask of the LAN: with less than 254 possible hosts (net-
mask > '255.255.255.0'), please ensure that the IP address
'x.x.x.254' is located in your own subnet.
If you have chosen automatic TCP/IP configuration, please continue with
Step .
Chapter 3: Basic configuration
Programs LANCOM
Find).
Find).
29