Access Points In Relay Mode - Lancom L-54g Wireless Manual

LANCOM L-54g Wireless - LANCOM L-54ag Wireless - LANCOM L-54 dual Wireless
You will find the WLAN MAC address on a sticker located under each of the
antenna connectors. Only use the string that is marked as the "WLAN MAC"
or "MAC-ID". The other addresses that may be found are not the WLAN MAC
address but the LAN MAC address.
Alternatively you will find the MAC addresses for the WLAN cards in the
devices under WEBconfig, Telnet or a terminal program under the following
paths:
Configuration tool
WEBconfig
Terminal/Telnet
Configuration with Under WEBconfig or Telnet you can set the settings for the point-to-point
WEBconfig or Telnet
connections under the following paths:
Configuration tool
WEBconfig
Terminal/Telnet
5.2.4

Access points in relay mode

Access points equipped with two wireless modules can be used to establish
wireless bridges across multiple stations. Each wireless module is configured
as a 'Master' and then 'Slave' in turn.
Master
GEBÄUDE
WLAN Router ANTENNE
Menu/Table
Expert configuration
face-statistics
Status/WLAN-statistics/Interface-statistics
Menu/Table
Expert configuration
faces
cd /Setup/Interfaces/WLAN-Interfaces/
Interpoint-Settings
Slave Master
BUILDING
ANTENNA DUAL RADIO AP ANTENNE
Chapter 5: Advanced wireless LAN configuration
Status
Setup Interfaces
Interpoint-Settings
Slave
BUILDING
ANTENNA DUAL RADIO AP
WLAN-statistics Inter-
WLAN-Inter-
LAPTOP/W-LAN
ANTENNA
57