Encryption Settings - Lancom L-54g Wireless Manual

LANCOM L-54g Wireless - LANCOM L-54ag Wireless - LANCOM L-54 dual Wireless
Under WEBconfig or Telnet the network settings for the logical WLAN
interfaces can be found under the following paths:
Configuration tool
WEBconfig
Terminal/Telnet
5.3.3

Encryption settings

For access to a WLAN, the appropriate encryption methods and key must be
set in the client station.
To enter the key, change to the '802.11i/WEP' tab under LANconfig in the
'Wireless LAN' configuration area. From 'WPA / private WEP settings',
select the first WLAN interface from the list of logical WLAN settings.
Enable encryption and match the encryption method to the settings for
the access point.
In WLAN client operating mode, the LANCOM Access Points and LANCOM
Wireless Routers can authenticate themselves to another access point
using EAP/802.1X. For this, select the desired client EAP method here.
Note that the selected client EAP method must match the settings of the
access point that the device is attempting to log onto.
Depending on the EAP method, the appropriate certificates must be

stored in the device.
Chapter 5: Advanced wireless LAN configuration
Menu/Table
Expert configuration Setup
work
Setup/Interfaces/WLAN/
Network settings
Interfaces WLAN Net-
63