Configuration; Port - Lancom GS-2310P User Manual

LANCOM GS-2310P/GS-2326(P) User Manual

3 Configuration

3 Configuration
This chapter describes all of the basic network configuration tasks which include the Ports, Layer 2 network protocol
(e.g. VLANs, QoS, IGMP, ACLs, and PoE, etc.) and any setting of the Switch.

3.1 Port

The section describes how to configure the Port detail parameters of the switch. You can use the Port configuration to
monitor, enable, or disable the ports of the switch.
5
The GS-2310P features SFP/RJ45 combo ports. Please note that SFP is always favored over RJ45. Hence, the RJ45
port is only available when there is no link on the corresponding SFP port.
3.1.1 Configuration
This chapter describes how to view the current port configuration and how to configure ports to non-default settings,
including
Linkup/Linkdown
Speed (Current and configured)
Flow Control (Current Rx, Current Tx and Configured)
Maximum Frame Size
Excessive Collision Mode
Power Control.
Web Interface
To configure a Port in the web interface:
1. Click Configuration, Port, then Configuration
2. Specify the Speed Configured, Flow Control, Maximum Frame size, Excessive Collision mode, and Power Control.
3. Click Apply.
Figure 3-1.1: The Port Configuration (GS-2310P)
12