Network; Lte - Teltonika RUT750 LTE User Manual

Network

LTE

Here you can configure the LTE specific settings which are used when connecting to your local LTE network.
The configuration is simple and straightforward. Here we will gloss over all the fields:
Field name
1. LTE connection
2. APN
3. PIN Number
4. Dialing number
5. Authentication
method
6. Username
7. Password
8. Service mode
Possible values Explanation
Use pppd mode Pppd mode uses dialing number to establish data connection.
Use NDIS mode NDIS mode (default) does not use dialing to establish data connection
Use bridge mode and is usually faster than pppd mode.
Bridge mode bridges LTE data connection with LAN. In this mode the
router does not have internet connection as ISP provides IP directly to
end device (PC, tablet or smartphone).
"bangapro" Access Point Name (APN) is a configurable network identifier used by a
mobile device when connecting to a GSM carrier.
"5555" or any A personal identification number is a secret numeric password shared
number that falls between a user and a system that can be used to authenticate the user
between 0000 and to the system.
9999
"*99#" Dialing number is used only in pppd mode to establish data connection.
CHAP, PAP or none Authentication method, that your carrier uses to authenticate new
connections. (This selection is unavailable on the alternate model)
"user" Your username and password that you would use to connect to your
carriers network. These field become available when you select an
"passwd"
authentication method (i.e. authentication method is not "none").
These fields are always enabled on the alternate model.
GSM, UMTS, LTE or Your network preference. If your local mobile network supports GSM
22