Teltonika RUT750 LTE User Manual page 19

Wireless
Wireless can work in two modes, AP or Client. AP is when the wireless radio is used to create an Access Point that other
devices can connect to. Client is when the radio is used to connect to an Access Point via WAN.
Client
Field Name Sample Value
1. SSID teltonika_rnd_division_ap The SSID that the AP, to which the routers is connected to, uses.
2. Mode Client
3. Channel 6 (2.44 GHz)
4. BSSID C8:3A:53:02:FC:B0
5. Encryption WPA2 PSK (CCMP)
6. Bit rate 65.0 MBit/s
7. Country LT
AP
Field Name Sample Value
1. Signal Quality 100%
2. SSID Teltonika_demo
3. Mode Master
4. Channel 6 (2.44 GHz)
5. BSSID 00:0C:43:30:50:38 MAC address of your wireless radio.
Explanation
Connection mode – Client indicates that the router is a client to
some local AP.
The channel that the AP, to which the routers is connected to, uses.
Your wireless radio is forced to work in this channel in order to
maintain the connection.
The MAC address of the access points radio.
The AP, to which the router is connected to, dictates the type of
encryption.
The physical maximum possible throughput that the routers radio
can handle. Keep in mind that this value is cumulative - The bitrate
will be shared between the router and other possible devices that
connect to the local AP.
Country code.
Explanation
The quality between routers radio and some other device that is connecting
to the router. Will show 0% if no devices are trying to connect or are currently
maintaining a connection.
The SSID that is being broadcast. Other devices will see this and will be able
to use to connect to your wireless network.
Connection mode – Master indicates that you router is an access point.
The channel which is used to broadcast the SSID and to establish new
connections to devices.
19