Target Audience, Prerequisites - Siemens RDG400KN Basic Documentation

ETS3 Professional
ACS Service
ACS Operating
Note!
STOP
K NX
R
6 / 78
Siemens
Building Technologies
1.4

Target audience, prerequisites

This document assumes that users of the RDG KNX thermostats are familiar with
the ETS3 Professional and/or Synco ACS700 tools and able to use them.
It also presupposes that these users are aware of the specific conditions associ-
ated with KNX.
In most countries, specific KNX know-how is conveyed through training centers
certified by the KNX Association (see www.konnex.org/).
For reference documentation, see section 1.2.
1.5 Glossary
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this document:
Parameters identified by this symbol are set using ETS3 Professional.
Parameters identified by this symbol are set using the ACS Service tool.
Parameters identified by this symbol can be monitored using the ACS Operating
tool.
Setting RDG KNX parameters is only supported by the following tool
versions:
– ETS3f or higher
– ACS700 version 5.11 or higher
Inputs and outputs identified by this symbol communicate with other KNX devices.
They are called communication objects (CO).
The communication objects of the RDG KNX thermostats work partly in S-mode,
partly in LTE mode, and partly in both. These objects are described accordingly.
A list of the parameters is shown in section 3.12.
RDG400KN Basic documentation
About this document
CE1P3192en
20 Jul 2010