Target Audience, Prerequisites; Glossary - Siemens RDG400KN Basic Documentation

ETS
ACS
Note
STOP
K N X
R
6 / 87
Siemens
Building Technologies
Siemens assumes no liability to the extent allowed under the law for any losses
resulting from a failure to comply with the aforementioned points or for the
improper compliance of the same.
1.5

Target audience, prerequisites

This document assumes that users of the RDG..KNX room thermostats are familiar
with the ETS and/or Synco ACS tools and are able to use them.
It also presupposes that these users are aware of the specific conditions associ-
ated with KNX.
In most countries, specific KNX know-how is conveyed through training centers
certified by the KNX Association (see www.konnex.org/).
For reference documentation, refer to section 1.2.
1.6

Glossary

The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this document:
Parameters identified by this symbol are set using the ETS tool.
Parameters identified by this symbol are set using the ACS tool.
Setting RDG..KNX parameters is only supported by the following tool
versions:
– ETS4 or higher
– ACS790
Inputs and outputs identified by this symbol communicate with other KNX devices.
They are called communication objects (CO).
The communication objects of the RDG..KNX room thermostats work partly in
S-Mode, partly in LTE-Mode, and partly in both. These objects are described
accordingly.
A list of the parameters is shown in section 3.12.
RDG400KN,RGD405KN Basic documentation CE1P3192en
2017-02-17