Installing Ft Server Control Software - NEC Express5800/R320c-E4 Installation Manual

Chapter 1 Installing OS
1.9

Installing ft Server Control Software

Connect to the ESXi host from vSphere Client to configure.
To install ft Server Control Software on the internal disks, insert a disk in slot 0 of the CPU/IO module
1.
1.
Set the ft Server Control Software Install DVD to the DVD drive of the machine where vSphere Client
2.
is installed.
Click the CD/DVD button on toolbar of vSphere Client to mount the ft Server Control Software Install
3.
DVD.
Log in to ftSys Management Appliance as a root user.
4.
The initial password is "ftServer."
Run the following command on ftSys Management Appliance.
5.
# /opt/ft/sbin/ft-install /dev/cdrom
When the IP address entry screen of the ESXi host appears, enter the IP address of the ESXi host,
6.
and press Enter.
Name or IP Address of the host machine[]: _
Enter the root user password of the ESXi host and press Enter.
7.
Administrative password for xxx.xxx.xxx.xxx: _
When the confirmation message appears, press y.
8.
Please refer to your system documentation before proceeding.
Do you want to continue [Y/n]: _
When the confirmation message appears several times, press y.
9.
Do you want to continue [Y/n]: _
10. The message as shown below appears, and the installation starts.
Installing to host xxx.xxx.xxx.xxx. Please wait...
Updating the host's system software...
11. When the reboot confirmation message appears at the end of the installation, press y. Confirm that
the ESXi host is shutdown, and then, remove the ft Server Control Software Install DVD.
A host reboot is required to place these updates into service.
Do you want to reboot now [Y/n]: _
12. The system reboots twice, and the ft module registration and disk duplication are performed. These
processes take several tens of minutes.
The time required for completing the duplication vaires depending on the disk space.
Note
Express5800/R320c-E4, R320c-M4 Installation Guide (VMware)
1. Setup Procedure
47