Modification Of Set-Point - Emerson XWEB3000 EVO Operating Manual

Complete Reduced
The status is shown in blue for the digital variables, and in red for the alarm
variables only.
In full view mode, it is possible to select or deselect the variables. The selection of each value allows it to be
included in the various page elements, such as in the graph shown below.

3.5.2.3 MODIFICATION OF SET-POINT

A set-point can be quickly changed by clicking on its value. The box then goes into edit mode, as
demonstrated below.
Enter the new set-point value and press "enter" to confirm. Confirmation of the entered value will be
requested before commanding that written by the set-point to the controller.
For each written phrase, the user will be notified as to whether or not the operation was carried out
successfully.
1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28 78/100