Variable Displaying - Emerson XWEB3000 EVO Operating Manual

Selecting a device displays:

the variables grouped by group of pertinence (Analogue/Status/Alarm etc..). section "deviceView";

the graph for the device. section "dataChart";

the list of available commands per device. section "commandButtons";

list of device parameters. section "parProg"
All page values and relative graphs are updated in real time (on polling time).

3.5.2.2 VARIABLE DISPLAYING

This section shows, for the chosen device, the list of variables to be monitored and their values in real time.
The variables are divided between the sections Analogue, State, Set-point, Alarms, Inputs and Outputs.
There are two types of display:

complete: corresponds to the presence of the key "Only active"
represented.

reduced: corresponds to the presence of the "Show all" key
limited to those in the "On" status. "On" corresponds to the presence of an alarm for the variables in the
"Alarm" section. This mode enables the list to be reduced to show only the variables of interest and
facilitate the operator in his/her reading.
1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28
. All device variables are
; displaying of the digital variables is
77/100