Emerson XWEB3000 EVO Operating Manual page 28

Category parameters:
- Name: identifies the category itself;
- Delay: stand-by time for the processing of the alarm, from when it is read by the controller network to
when it is effectively considered an alarm: if the alarm is resolved before this time runs out, the source of
the alarm is ignored. This parameter is useful for the delayed management of the "open door" status
which comes from an I/O board: the variable is not an alarm but with the XWEB-EVO it can be used as if
it were.
- Accumulation time to alarm reset: the system sends notification when the alarm is reset. However, the
system waits for the resetting of other alarms for the period indicated in this parameter, before sending a
cumulative notification. This therefore reduces the notification line's task; relieving it of any critical
conditions such as is the case when the line is slow (e.g. fax line). This parameter works similarly to the
"Accumulation" time present amongst the "alarm notification parameters": However, in the case of the
alarm-categories, the time is divided between all of the "Alarm Level Settings";
- Alarm-Level Settings: notification level. The order is important: the first level to be notified (entry level)
is that with the lowest number ("Setting 1"). The up-scaling of the notification level occurs based on the
parameters set in "Settings".
- Alarm types, quick configuration (optional): list of all types of alarms recognisable in the configured
devices. The sole selection of the types does not change the alarm-category configuration. But on the
contrary, prepares the category for the receipt of these alarms the next time the User assigns a device to
the same category. Example: having configured the category with a "High Temperature" alarm, drag a
list of controllers and drop into the same category: this assigns the "High Temperature" alarm for all
devices in the list for the category.

Level Parameter Tab
The alarm notification parameters identify the notification levels. Each level includes the users who receive
the alarm notifications.
- press "+" to add a new level
- to modify the level parameters press
- to eliminate the level press
1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28 28/100