Start Fast Acquisition Modem (Fsm) - Emerson XWEB3000 EVO Operating Manual

Set-point change successful Set-point change with error
To perform this operation, the page must be in full view mode.

3.5.2.4 START FAST ACQUISITION MODEM (FSM)

The FSM mode aims to perform a high speed selective monitoring of the resources for a set time limited to
10 minutes. This type of monitoring allows the user to run the controller debug and/or of its application, as if
the other devices were "disconnected" from the tool network. The delay in the acquisition time of the
controller values is at a minimum, the device is read more or less in real time.
Attention: to allow for a higher speed of a controller, the others will be affected. During FSM mode, the
sampling time of the other controllers may appear to have increased.
To run the FSM procedure on a controller, firstly, select the variables of interest from the "device view"
section and then press "Start FSM" . When this is pressed, the following message appears requesting
confirmation before starting the procedure:
Once confirmed, the user will be warned that the acquisitions have entered in FSM mode for the device.
The FSM mode saves all read samples in the main data archives. All data sampled during FSM mode is
marked as such and represented in the graphs by a light-blue background.
1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28 79/100